Sensormatic VM 8 Operator's Manual download pdf (Page 57)

4-12 Operator's Manual

state, and this triggers an alarm. (Refer to your List of Inputs and Outputs in

Appendix A to determine the normal and abnormal state for each input.)

When an alarm is triggered, it can automatically call up one video action

(either a Quick View, a Pattern, or a fixed shot) and initiate one output. This

video action must have been defined for the same dome that the output is

connected to, and vice versa. Refer to the List of Inputs and Outputs in

Appendix A to determine which output devices are connected to which

domes. Refer to your List of Quick Views and List of Patterns in Appendix A

to determine which Quick Views and Patterns were defined for which domes.

It might be helpful for you to fill out the Setup Alarms Worksheet in

Appendix A before you begin setting up an alarm. On the Setup Alarms

Worksheet, you can calculate which inputs on which domes will trigger

which video action and output, if any. You can then refer to this worksheet

when you are actually setting up an alarm.

Tip: You must use the Main TOUCH TRACKER to set up Alarms.

The following procedure describes how to set up a system alarm.

1. Using the number buttons, enter the number of the camera for which you

are setting up the alarm. Then press

(the Camera button).

2. Press the Menu button.

The TOUCH TRACKER is now in the menu/programming mode, and the

menu appears:

Define Sequence

Setup View

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 111 112

No comments

Sensormatic VM 8 Operator's Manual Page 57