Sensormatic VM 8 Operator's Manual download pdf (Page 40)

Controlling Cameras and Their Outputs 3-9

When you run a Pattern, you can specify to run the Pattern once, or you can

specify to run the Pattern repeatedly until you stop it manually. Both methods

are described here.

If a list has been compiled for your facility, you can refer to the List of

Patterns in Appendix A to determine which Patterns are available for which

domes.

The following procedure describes how to run a Pattern. Most programmable

domes support up to three Patterns defined for it. The SpeedDome LT will

support programming the Auto Pan feature for Pattern 1; it does not support

programming any additional patterns.

1. Use the number buttons to enter the number of the camera whose Pattern

you want to run. Then press

(the Camera button).

2. Use the number buttons to enter the number of the Pattern you want to

run. Then press the Pattern button (if you want the Pattern to run one

time and then stop), or press the Repeat Pattern button (if you want the

Pattern to repeat indefinitely until you stop it).

If that Pattern exists for that camera, the Pattern will automatically begin

running. If that Pattern does not exist for that camera, the camera will run

the default Apple Peel pattern, described previously.

Depending on whether this is a Pattern that will run once or a repeating

Pattern, one of the following messages appears on the LCD:

Cam 8 +

Run Pattern

Cam 8 +

Repeat Pattern

-or-

If you instructed the Pattern to run through one time, the following

message appears on the LCD once the Pattern is complete:

Cam 8 +

Pattern Done

If you instructed the Pattern to repeat itself, the Pattern will continue

running until you manually issue a camera command (pan, tilt, zoom,

focus, or iris) to the dome running the Pattern.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 111 112

No comments

Sensormatic VM 8 Operator's Manual Page 40