Sensormatic VM 8 Operator's Manual download pdf (Page 39)

3-8 Operator's Manual

1. Use the number buttons to enter the number of the camera whose Quick

View you want to display, for example, camera 12. Then press

(the Camera button).

2. Use the number buttons to enter the number of the Quick View you want

to display, and then press the View button.

If the Quick View exists for the selected camera, the camera will immediately

point to the pre-defined Quick View, and then zoom and focus

automatically. The following message appears on the LCD:

Cam 12 +

View

If you attempt to call up a Quick View for a non-programmable dome, or

if you entered an invalid View number (any number greater than 96), the

OUCH TRACKER beeps.

Running Patterns

IMPORTANT

The SpeedDome LT supports a feature called “Auto Pan” that allows you to

program a smooth side-to-side camera movement for an area. Please refer to

the section in Chapter 4 titled “SpeedDome LT Auto Pan Programming” for

additional information.

A Pattern is a sequential series of pan, tilt, zoom, and focus movements from

a single camera. You “teach” the camera a combination of these movements.

Then when you run the Pattern, the camera automatically repeats the

movements you taught it.

You can define your own Patterns to support your specific needs. Refer to

Chapter 4, “Defining Automatic System Functions,” for procedures on

defining Patterns.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 111 112

No comments

Sensormatic VM 8 Operator's Manual Page 39