Sensormatic VM 8 Operator's Manual download pdf (Page 49)

4-4 Operator's Manual

Tip: A shortcut method for defining Quick Views is available. Press Menu,

View, the Quick View number, and Zoom or Focus to create a Quick

View of the current scene.

Defining a Pattern

Note The SpeedDome LT does not support Pattern programming. Refer to the

section in this chapter titled “SpeedDome LT Auto Pan Programming” for

information about setting the Auto Pan feature.

You can define your own Patterns to support your specific needs.

You can program up to three Patterns per programmable dome. The length

and complexity of a Pattern are restricted by two variables:

• Number of camera commands

• Time

Each time you move the camera in any direction, zoom in or out, focus near

or far, or adjust the iris, you have issued camera commands to the camera.

The three Patterns for a dome can collectively consist of up to 98 camera

commands. As you program a Pattern, the number of camera commands

remaining for that camera appears on the T

OUCH TRACKER LCD.

There is also a time constraint on Patterns. A single Pattern cannot have a

duration longer than approximately 6 minutes and 50 seconds. Even if a

Pattern has only two camera commands in it, the Pattern will stop recording

once its duration time has elapsed.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 111 112

No comments

Sensormatic VM 8 Operator's Manual Page 49