Sensormatic VM 8 Operator's Manual download pdf (Page 43)

3-12 Operator's Manual

Inputs and Outputs. You must know the number of the dome (1 – 16) that the

output is connected to, and the output number (1– 4) before you begin this

procedure.

1. Refer to your List of Inputs and Outputs to determine which output you

want to turn on or off.

2. Use the number buttons to enter the number of the camera whose output

state you want to toggle. Then press

(the Camera button).

3. Use the number buttons to enter the number of the output you want to

control. Then press the Output On button (if you want to turn the output

on), or press the Output Off button (if you want to turn the output off).

The List of Inputs and Outputs provides the on and off states for each

output.

Depending on whether you turned the output on or off in the previous

step, the LCD displays one of the following messages:

Cam 13 +

Output On

Cam 13 +

Output Off

-or-

If you entered an invalid output number (any number greater than 4 or an

output that does not exist) the T

OUCH TRACKER beeps.

Clearing System Alarms

Tip: Alarms can be cleared from the Main TOUCH TRACKER only.

Your system can be configured to handle up to 64 different alarms. When an

alarm is triggered, it takes precedence over whatever you are doing on the

Main monitor and Main T

OUCH TRACKER at the time. For example, if you

are in the programming mode when an alarm comes in, the alarm information

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 111 112

No comments

Sensormatic VM 8 Operator's Manual Page 43