Sensormatic VM 8 Operator's Manual download pdf (Page 48)

Defining Automatic System Functions 4-3

4. Use the Tracker Ball to scroll through the menu selections until Setup

View is displayed on the LCD.

Setup View

Record Pattern

5. Press the appropriate button, zoom or focus, to select Setup View.

The following prompt appears on the LCD:

Cam 7

Enter View#?

Note If you press a number that has been assigned to an existing Quick View for

this camera, the new Quick View will overwrite the existing Quick View.

There is no warning to indicate that the existing Quick View will be

replaced. Use caution.

6. Press the number on the keypad (1 - 96) that you want to assign to this

Quick View, then press Zoom or Focus.

The following message appears briefly on the LCD:

Cam 7

View Saved

If you press an invalid number (any number greater than 96), the TOUCH

TRACKER beeps, and the system will not save the Quick View. If this

happens, simply press a valid number and the Quick View will be saved.

The T

OUCH TRACKER automatically returns to the camera control mode.

In the List of Quick Views (found in Appendix A), make a record of the

Quick View you just defined, including a brief description of what the Quick

View is “looking at.”

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 111 112

No comments

Sensormatic VM 8 Operator's Manual Page 48