Sensormatic VM 8 Operator's Manual download pdf (Page 50)

Defining Automatic System Functions 4-5

Patterns are programmed in real-time. This means that the camera is

remembering every programming command you make at the actual speed

you issue the commands. For example, if you let the camera sit still for 20

seconds during programming, the camera pause for 20 seconds each time that

Pattern runs in the future. The 20 seconds of “non-motion time” is part of the

Pattern.

Tip: You must use the Main TOUCH TRACKER to define Patterns.

If you make a mistake during programming or you no longer want to

program the Pattern, press the Menu or the Clear button at any time to

cancel programming. The T

OUCH TRACKER returns to the camera control

mode.

The following procedure describes how to define a Pattern.

1. Using the number buttons, enter the number of the programmable camera

for which you are defining the Pattern (for example, camera 3). Then

press the Camera button.

2. Pan and tilt the camera to the starting point of the Pattern, and then zoom

and focus the camera accordingly.

3. When you have the perfect “starting point” picture displayed on the

monitor, press the Menu button.

The TOUCH TRACKER is now in the menu/programming mode, and the

menu appears:

Define Sequence

Setup View

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 111 112

No comments

Sensormatic VM 8 Operator's Manual Page 50