Sensormatic VM 8 Operator's Manual download pdf (Page 38)

Controlling Cameras and Their Outputs 3-7

Cam 2 +

Apple Peel Patn

The Apple Peel pattern will repeat itself indefinitely until you issue a camera

command (pan, tilt, zoom, focus, or iris) to the dome running the pattern.

Displaying Quick Views

IMPORTANT

The SpeedDome Ultra III and newer domes support up to 96 views. Other

domes support up to 4 views. The Touch Tracker beeps when you attempt to

call up a view numbered higher than 4 on domes older than the SpeedDome

Ultra III.

A Quick View enables you to instantaneously call up a specific view from a

programmable dome, regardless of where that dome is currently pointing. A

Quick View is useful when you want to look at a particular item or area

immediately. You may not want to have to manually pan and tilt the camera

to the specific area, and then zoom and focus.

You can define your own Quick Views to support your specific needs. Refer

to Chapter 4, “Defining Automatic System Functions,” for procedures on

defining Quick Views.

The View button on the keypad allows you to call up the Quick Views that

you have defined for your cameras. Depending on the type of dome, either 4

or 96 Quick Views may be defined.

If a list has been compiled for your facility, you can refer to the List of Quick

Views in Appendix A to determine which Quick Views are available for

which domes.

The following procedure describes how to display a Quick View.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 111 112

No comments

Sensormatic VM 8 Operator's Manual Page 38