Sensormatic VM32 Operator's Manual download pdf (Page 34)

Controlling Monitors, Cameras, and Output Devices 2-11

device. You can control the state of any output device connected to the

system by using the T

OUCH TRACKER.

There can be up to 129 output devices (128 for domes, 1 for the video matrix

switcher) configured at a single facility. It is useful to post information about

the output devices near to the T

OUCH TRACKERs. The Dome Configuration

Worksheet in Appendix A allows you to write the information about your

dome outputs in an easy-to-read table. You should make copies of this

worksheet for each dome installed at your facility. Appendix A also includes

a worksheet for your video matrix switcher. Keep all of this information with

the T

OUCH TRACKERS. By doing this, the TOUCH TRACKER users can easily

determine what outputs are available, as well as the on and off states for each

output.

Controlling Dome Outputs

The following procedure describes how to turn a dome output on and off.

The on and off states for each dome output are listed on the Dome

Configuration Worksheet found in Appendix A. You must know the both the

dome number (1 – 32) and the output number (1– 4) before you begin this

procedure.

1. Refer to the Dome Configuration Worksheet to determine which output

you want to turn on or off.

2. Use the number buttons to enter the number of the camera whose output

state you want to toggle. Then press

(the Camera button).

3. Use the number buttons to enter the number of the output you want to

control. Then press the Output On button if you want to activate the

output, or press the Output Off button if you want to deactivate the

output. The worksheet in Appendix A provides the on and off states for

each output.

Depending on whether you turned the output on or off in the previous

step, the LCD displays one of the following messages:

CAM 4 OUTPUT

MON 1 3 ON

–OR –

CAM 4 OUTPUT

MON 1 3 OFF

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 119 120

No comments

Sensormatic VM32 Operator's Manual Page 34